What we do
We program the PLCs, HMIs, and VFD drives that run your line — new builds, modifications, and troubleshooting when they fault. If a controller runs the machine, we write the logic, wire it in, and commission it so the line runs the way it should.
HMI design & programming
We design and program the HMI operator screens your team runs the line from — new interfaces and changes to existing ones, built so the next shift can read them.
VFD programming & drives
We set up and tune the VFD drives that control your motors — new drives, replacements, and drives that stopped holding.
What you get
Programmed, wired, tested, and left running — with documentation the next shift can actually use.
- Logic written and commissioned on-site
- Wiring checked and labelled
- Tested against the running process before we leave
- Documentation handed over
When a controller faults and the line is down, don’t wait on the programming queue — see Emergency / line-down.